1)The shapes of the bending are rich"U","O"type
2)NC control,the simple basis,easy to move
3)roller hardness HRB45
1)The shapes of the bending are rich"U","O"type
2)NC control,the simple basis,easy to move
3)roller hardness HRB45 -55
Main characteristic
- High-precision end of the pre-bending, set the length of the straight edge freely; direct pressure on the pre-roll bending, high-precision can be completed in advance of the end of the bend.
- NC control, high productivity products rolling process parameters NC, simple and substantial increase in efficiency.
- The roller assumes the bulging form on products accuracy hyper group, have asking a roller to coordinate adjustment ,continuous bending on time of roller lower part, this one broad range inner is able to make ideal products roll from lamina to plank
- Operating under the security of two fixed roll, roll up and down on, move around, do not work with mobile work roll, operations safely.
- The overall structure , the basis is simple, convenient movement, device uses a whole-chassis, do not need to bolt, the basis is simple, the movement of workplace is convenient.
- Use are different, corresponding method to control use in accordance with the following control methods: TNC (at NC):multi-species, with a small amount of production: T &BNC.
- Many kinds of shapes of the O-type, U-type, multi-paragraph R,cone cylinder auxiliary device, you can roll a range of cone-cylinder. O-bending : bending the back way; U-bend: the way forward bending. Bend with type R,ways of combination.
W11S-25x3000, the technical parameters
Pressure of upper roller 23000kgs
Diameter of upper roller 420mm
Diameter of under roller 235mm
Center distance 350mm
Speed of roll 4m/min
Main motor 30kw
Hydraulic motor 11kw
Movement motor 4kw